Said that the ceiling by three points by the installation of quality, ceiling installation is very important, before Xiao Bian introduced to the aluminum buckle plate ceiling installation procedures, do not know the installation of the aluminum buckle ceiling occasionally there will be some problems, this article is small A few common problems and reasons after the ceiling installation of the aluminum buckle plate were compiled and hoped to help everyone solve the problem.
1. After the installation of the ceiling of the aluminum pinch plate is completed, the most edged plate is touched by the hand and it goes up. This phenomenon is often due to the fact that the workers did not open the bayonet on the corners, and sometimes the workers neglected the problem because they were careless. Therefore, this is also one of the criteria for checking whether your home aluminum buckle is lifted.
Second, after the completion of the installation of the ceiling of the aluminum buckle plate, the corners will start to warp or open the glue within half a month. This phenomenon can not be generalized, there are generally two ways to install the corners, using different installation methods, the reasons for the corners of the tilt is not the same.
Install the corner way 1, with glue. A few years ago, this method of using glued corners was the most common method. However, some workers may have corners when they are installed due to insufficient glue or poor glue quality. This method is now generally no longer required for formal decoration companies because of too many sequelae.
Install the corner mode 2. First, make a hole in the wall, align the hole in the corner with the hole in the wall, and fix the corner on the wall with a nail. The advantage of this method is that it does not use glass glue. It is fixed more firmly and does not fall off easily. However, fixing with this method requires the owner to ensure that there is no problem with the wall tiles and that there will be no void. If the wall tiles are pasted with holes, it is easy to crack the wall tiles. So this side can also test the paste technology of the wall tiles.
3. After the ceiling installation of the aluminum pinch plate was completed, there was a gap between the individual aluminum pinch plates. This problem is the most common problem in the ceiling of aluminum buckles. The cause of this phenomenon can basically be determined by the negligence of construction workers, resulting in the installation of aluminum buckles not being in place. It is also possible that the construction staff has poor technology and installation of keel. Uneven.
4. After the installation of the ceiling of the aluminum buckle plate is completed, there will be a large gap. It is very likely that the aluminum buckle plate and keel you bought are not supporting products. The supporting keel produced by regular manufacturers is very tight after being buckled, and the pitch of the keel and plate is also very accurate.
The above are the four problems that often exist after the ceiling installation of aluminum buckles. Xiao Bian has listed the reasons for the problems. We can look for solutions according to different reasons, or visit the website to find information.
More exciting recommendations:
Aluminum buckle ceiling how to introduce aluminum ceiling ceiling
Six recommendations for ceiling design
4 kinds of style ceiling ceiling decoration renderings
Five design methods for ceilings
Aluminum buckle plate ceiling integrated ceiling decoration design glass style decoration ceiling effect map decoration ceiling renderings ceiling decoration effect drawing decoration decoration company look good decoration style glass brick
2 Person Hot Tub
2 Person Hot Tub,small outdoor spa tubs,backyard hottub,outdoor whirlpool hot tub,outdoor jacuzzi hot tubs
Guangzhou Aijingsi Sanitary Products Co.,Ltd , https://www.infinityedgehottub.com