Summer has been the peak period for the problem of laminate flooring. Since the beginning of the summer, various regions of the country have ushered in the baptism of heavy rainfall and high temperature to varying degrees, so that the probability of problems with the laminate flooring in the home has greatly increased. If the maintenance of the laminate floor is not enough, in the case of soaking water, how to care for the laminate floor in the best way? Here are four cases of strengthening the floor soaking water and the solution after soaking water.
1. Intensified floor soaking occurs, and the surface water on the reinforced floor should be drained in the shortest time. At the same time, take the vacuum cleaner to absorb the water vapor in the splicing gap of the water-enhanced floor, or use a hair dryer to blow dry with cold air, but never use hot air to prevent the surface from being dry-deformed due to heat drying.
2. For the laminate flooring that has been warped and deformed, it is best to replace it. It is not recommended to plan the part of the arched and repainted, because after the arching part is leveled, repainting will lead to other board colors. Uncoordinated, and the entire board is uneven in thickness, the force is different, and pits are prone to occur.
3. If it is a large area of ​​water, it should be promptly notified to the after-sales service of the laminate floor, and carefully lift the wooden floor under the condition that the laminate floor is not deformed as much as possible, and put it in the ventilated place in the shade of the “well†type. Use the weight generated by the lamination to prevent the occurrence of deformation, and be careful not to expose it to the sun. Generally, it can be used again for the better quality laminate flooring.
4. If it is a small area of ​​water, it is recommended not to pick up the floor to dry, so it is easy to cause hard damage to the floor, it may cause serious consequences that cannot be restored. It is best to quickly remove the baseboard of the floor, reveal the expansion joints, and disperse the water vapor through the expansion joints. It usually takes about three to ten days to dry depending on the amount of water seepage.
Auxiliary Agent For Alloying /Calcium Carbide
This is used for making Calcium Carbide and smelting as an agent. It is not the raw material, but it is an important agent during production.
Auxiliary Agent For Alloying /Calcium Carbide
Auxiliary Agent,Auxiliary Agent For Alloying,Auxiliary Agent For Calcium Carbide
NINGXIA PURU CHEMICAL CO., LTD , https://www.nxpuruchem.com