Nowadays, people are increasingly pursuing the beauty of the house. When the house is renovated, it is necessary to install a skirting board. It not only protects the wall, but also perfectly integrates the floor and the wall. So, what is the skirting installation procedure? What needs special attention? Let's talk about it with Xiaobian.
First, what is the installation step of the baseboard?
1, wooden skirting installation
The first step is to measure the position of the baseboard to be installed and then cut the skirting board to the proper size.
The second step, when drilling, should pay attention to the interval can not be too large, so that because the interval is too large, the baseboard can not stick to the wall.
The third step is to cut the edges into 45-degree angles during installation and then splicing them together for installation.
2, tile skirting installation
The first step is to wet the tiles in advance, clean the walls, and cut the baseboard at an angle of 45 degrees.
The second step is to test the cut baseboard to see whether there will be gaps, whether there will be missing corners or not, and check if there is no such problem before installing.
The third step, the installation of tile skirting can be divided into paste, grouting two methods, regardless of which of the above methods, the installation must first install a baseboard at both ends of the wall, and then according to this kick Lines are installed block by block.
3, stainless steel baseboard installation
The first step is to make a positioning rule before installation.
The second step is to clean the position where the skirting line needs to be installed. Scrape the protruding area and install a suitable gasket in the recessed area.
In the third step, there are two ways to install snaps. One is to fix them with cement pins, and the other is to use a percussion drill to drill and fix them. After confirming that they are on the same straight line, cut them according to their size. Grinding. When installing, the protective film of the baseboard must be torn off and the sealing should be done after installation.
The fourth step, after installing the baseboard, use silicone to seal the gap.
Second, the installation of the baseboard which need special attention
1. Most of the baseboards used in your renovation have the characteristic of thermal expansion and contraction, so you must leave a gap of about 1 cm for either the walls or the floor.
2, in order to make the baseboard more solid, better close to the wall, must be fixed with a special nail.
3. When installing the skirting board, be sure to pay close attention to the wall or the floor when installing, especially where there are corners and corners. Be careful not to leave gaps.
Editor's summary: The above is what the skirting line installation steps for Xiaobian share with you. And what information needs to be taken into account when installing the baseboard. If you want to learn more about decoration, you can follow this website.
Earphone Cases,Earphone Eva Case For Bluetooth,Bluetooth Earphone Eva Case,Earphones Eva Cases
Dongguan C.Y. RedApple Industrial Limited , https://www.redapplebags.com