Steps and methods for starting a small gasoline generator set (2)

Steps and methods for starting a small gasoline generator set (2)

After the gasoline generator sets are started, large dampers must be opened. Run at low speed for 3 to 5 minutes (in cold regions, run at a low speed for about 10 minutes after starting). After the standby parts are well lubricated and the temperature rise is normal, gradually increase the rotation speed and fine tune the main oil pin according to the operation conditions. Such as the muffler "fire", the speed is unstable, even when the machine is shut down, should open a large main oil needle; muffler smoke and the speed is unstable, should close the main pin, make the speed stable. Observe the frequency table. If the pointer is stable at 50Hz, adjust the voltage to 220V and wait for power supply.

After receiving the power transmission notice and confirming that the power supply will not be mistaken, that is, when all switches are in the disconnected position, first close the load automatic switch on the distribution box of the gasoline generator set (from "OFF" to "ON" ), then plug in the AC output plug, and finally close the double-pole double-throw switch on the wall switch board (fall to the generator side). After the power supply, it should be adjusted according to the change of voltage and frequency when the user load increases or decreases. Avoid starting impact power loads. Gasoline generators can operate stably.