During the renovation of the “bathroomâ€, the need for waterproof and moisture proof should be considered from the laying of tiles and tiles, the treatment of ceilings, the installation of pipelines and the selection of equipment, and careful arrangements should be made.
>>> Links: Construction Technology for Bathrooms
Wall tiles and stone should be laid under the surface to make a waterproof layer. The cement mortar should be used to level the ground and apply waterproof coating. Afterwards, a layer of cement mortar of 1 to 2 should be used as a bonding layer to adorn the tiles and other decorative materials. After being watered, it is tamped with wooden boards to achieve a firm and tight joint. Before stone paving, back-coating should be done to reduce the phenomenon of “water stainsâ€. The contact area of ​​the waterproof layer with the wall should be turned upwards, about 25 to 30 cm above the ground, and the wash cabinet should be 1.0 to 1.2 meters above the ground, and the shower should be 1.8 meters above the ground. If you do paint decoration should first brush waterproof putty and use waterproof coating. The ground surface layer of flowing water should be drained to the ground, and the pan and water should not fall. After 24 hours of storage test, there is no leakage.
Ceilings are recommended to use microporous aluminum gussets to enhance ventilation and prevent condensation. If you do plasterboard ceiling, you should first brush waterproof putty, and then brush waterproof coating; PVC ceiling is easy to produce condensation, and drop, should be used with caution.
Pipeline installation to avoid changing the original up and down the pipe, must be horizontal and vertical decoration, laying a firm, slope meet the requirements. Valves, faucets are installed with a flat surface, flexible and easy to use, bright tube brush anti-rust paint, dark pipe brush anti-corrosion paint. The water supply pipe is closely connected with accessories and appliances, and there is no leakage through the water test. Floor drain design is still based on the above drainage pipeline, and the surface should be slightly lower than the ground.
The sanitary appliance is installed in the correct position and the appliance has to be level on its top edge. “Bathroom†appliances should be branded and have good waterproof performance, such as bath warmer lamps that are used in humid environments for a long time. The enclosure should be made of stainless steel, with good anti-corrosion performance, and waterproof power switches, cables and plugs. When electricity is used or when power is off, it is not afraid of water or water splashing, and it will not cause leakage or damage. Need to be equipped with waterproof shades, waterproof sockets and so on.
In the "bathroom" should be avoided to use wood materials, it is necessary to use, should use fire board or do a full mix of oil decoration, can be waterproof. In the ceiling or other package decoration, the hidden wooden keel needs to be painted with a waterproof coating or antiseptic.
It is very important for the "bathroom" to maintain a good ventilation environment. The use of good quality ventilation equipment helps to quickly evaporate moisture and vapors and keep the interior fresh and clean. Do a good job in the above aspects, you will be able to experience the bathing experience of human beings and nature in a completely relaxed state.
Bathroom Coatings Bathroom Cement Decorative Paints Bathroom Doors Bathroom Ceiling Material Bathroom Ceilings Bathroom Design Bathrooms Waterproof Bathroom Tiles
Rx Ring Joint Gasket,Rx Ring Gasket,Rx And Bx Ring Gasket,Rx Ring Joint Gaskets
WENZHOU JINGWEI SEAL TECHNOLOGY CO., LTD , https://www.ringjoint-gasket.com